BEARWARE 302363 Manual De Usuario página 17

6. Another short press of the "FUNC" button causes the display to show the
current total price of rate 2 and the entire time of rate 2.
You return to the default screen after another short press.
If you wish to reset the current usage, navigate to the price menu (4.) using the
"FUNC" button and press and hold the "FUNC" button for a few seconds till the
actual price is reset. If the maximum usage or the total electrical load is exceeded,
then "OVER" is displayed.
9 Setting the timer
Press and hold the "SET" button in the default screen to go to the date and time
settings. Then the weekday blinks. Select the current weekday using the UP" but-
ton and confirm it using the "SET" button. Now the hours display starts to blink.
Select the current hour. Repeat the process for setting the minutes.
To switch between the 12 hour and 24 hour display, press the "UP" button in the
default screen.
Note: Repeat the above mentioned steps to correct incorrect time settings.
10 Setting the costs per Kilowatt-hour (kWh)
Press and hold the "FUNC" button for about 2 seconds during the display modes
Voltage, Current or Power. A menu appears for setting the corresponding tariff.
Press the "SET" button once briefly while the timer clock is in the tariff display.
Now you can adjust the costs per kilowatt­hour using the "UP" button. Confirm
the settings each time by pressing the "SET" button. Then the weekday starts to
blink. Set the desired weekday or the desired weekdays (as a group) using the
"UP" button. Confirm again using the "SET" button. Then the "ON TIME" display
begins to blink. Set the desired hours and minutes using the "UP" button and
confirm it using the "SET" button. After setting Tariff 1 successfully, if desired, you
can switch to Tariff 2 using the "FUNC" button and set it in the same way as in the
steps described above.
Note: The display of the current costs is related to the tariff and the weekdays or
weekday groups assigned to the tariffs.
English
17