Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BASIC GUIDELINES
t.
Open the door and load your dishes (see page 16).
Place dishes into the upper and lower racks, unless you have selected
half load.
Remove any food remains from the dishes before placing them in the rack(s).
After placing the dishes into the racks, rotate the nozzles by hand to check whether
any of the
dishes will interfere with them.
Make sure the dishes will not prevent the detergent
dispenser
from opening.
2.
Add detergent
to the dispenser
(see page 18).
Make sure to use only automatic
dishwasher
detergent.
Refer to "Using
the dispenser"
on how to add detergent.
3.
Close the door.
Push the racks back so that they are in place, and then close the door.
Make sure to close the door firmly. If the door is slightly ajar, the selected
cycle will not start
automatically
4.
Touch the Power
button.
When you press the Power
button,
the entire display turns on and off, and then the cycle light of the
most recently finished
cycle lights up.
If "Low Rinse" is illuminated,
you should
refill the rinse aid dispenser
to improve
washing
and drying
performance.
5.
Select an appropriate
cleaning
cycle depending
on the soil level of the dishes. (see pages 10 and 22).
Touch the appropriate
cycle button.
When you touch
a cycle button,
the cycle indicator
light is illuminated.
If you touch the cycle button
again, the light turns off and the cycle is canceled.
For information
about selecting
a cycle according
to the soil level of the dishes, see "Cycle
Selector".
6.
Touch
the Start/Drain
button.
The dishwasher
will start draining after a few seconds,
and then start the cycle you selected.
7.
When the wash cycle is completed.
The Clean
light illuminates
and the dishwasher
sounds
a chime.
The power is automatically
turned off after 10 minutes.
/_k
If you want to load more dishes or pause the dishwasher
while it is already
running,
make sure to open
.......
_
the door slowly and carefully as there is a possibility
of injury from the hot steam inside the dishwasher.
(If the door is opened while the dishwasher
is running,
a safety mechanism
is activated
and stops the
cycle.)
You should
use rinse aids for better drying performance.
You can further improve
drying performance
by also selecting
the Sanitize option.
If the "Low Rinse" lamp lights during
a cycle, the dishwasher
adds 30 more minutes to the Drying cycle
automatically
after the Clean light illuminates.
When the water temperature
of the last rinse of the Sanitize option reaches the sanitary temperature
(over 155 °F (68 °C)), the Sanitize lamp blinks, and then remains illuminated
until the Sanitize option
ends. When you open the door or press the Power button, the "Sanitize"
lamp turns off.
12 usinq your _dishwasher
Publicidad
Tabla de contenido
