Safety Warnings; Installation Warnings; Warnings For The User - Palazzetti ECOFIRE Manual De Instalación, Uso Y Mantenimiento

Estufas de pellets de aire
Ocultar thumbs Ver también para ECOFIRE:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

2 SAFETY WARNINGS

2.1 INSTALLATION WARNINGS

Comply with the requirements speci¿ ed in this manual.
The stove assembly and dismantling instructions are
reserved exclusively for specialist technicians.
Users should always contact our service centre to
request work to be performed by quali¿ ed technicians.
Before having work performed by other technical
personnel verify their effective technical competence.
Responsibility for work carried out in the place where
the stove is installed lies with the user; the user is also
responsible for making sure the installation checks are
completed.
The user must abide by all local, national and European
safety requirements.
The appliance must be installed on À oors with a
suitable load-bearing capacity.
Make sure that the À ue and air intake duct
arrangements correspond to the type of installation.
Do not make any electrical connections using
temporary or uninsulated cables.
Make sure the electrical system is earthed correctly.
Before starting to assemble or dismantle the stove, the
installer must heed the safety precautions required by
law, speci¿ cally:
A) do not work in adverse conditions;
B) always be in a ¿ t mental-physical state for working
and make sure that personal protective equipment
is in perfect working order;
C) always wear safety gloves;
D) always wear safety shoes;
E) always use electrically insulated tools;
F) make sure that the area being used for assembly
and dismantling is clear of any obstacles.
2.2 MAINTENANCE WARNINGS
Comply with the requirements speci¿ ed in this
manual.
Use always personal protective equipment and
other means of protection.
Before starting any maintenance work make sure
that the stove, if it had been operating, has cooled
down.
If even just one of the safety devices is not
calibrated or not working, the stove must be
considered out-of-service.
Disconnect power before working on electrical or
electronic parts and connectors.

2.3 WARNINGS FOR THE USER

Prepare the stove installation site in accordance
with local, national and European regulations.
As the stove is a heating appliance it has very hot
outside surfaces. For this reason maximum care
must be paid during operation, speci¿ cally:
do not touch or get too close to the glass door to
avoid getting burned;
36/144
INTRODUCTION
INSTALLATION MANUAL
• do not touch the À ue;
• do not perform any type of cleaning;
• do not remove the ash;
• do not open the glass door;
• do not open the ash bin (where featured);
• make sure children keep away from the stove.
Comply with the requirements speci¿ ed in this
manual.
Follow the instructions and warnings highlighted
on the metal labels af¿ xed to the stove.
These labels are safety devices, therefore they
must always be perfectly legible. If damaged or
illegible they must be replaced, contacting the
manufacturer for an original spare label.
Only use fuel compliant with the speci¿ cations
shown in the corresponding chapter of this
manual.
Strictly follow the routine and special maintenance
plan.
Do not use the stove without ¿ rst having performed
the daily inspection as speci¿ ed in the chapter on
"Maintenance" in this manual.
Do not use the stove in the event of malfunctions,
suspected breakage or unusual noises.
Do not pour or spray water onto the stove when
operating or to extinguish the À ame in the burn
pot.
Do not switch the stove off by unplugging the
power cord.
Do not rest your weight on the open door as this
may affect stability.
Do not use the stove in any way as a support or
anchor.
Do not clean the stove until the structure and ash
have completely cooled down.
Touch the door only when the stove has cooled
down.
Perform all operations without haste, in such a
way as to ensure maximum safety.
In the event of ¿ re in the chimney switch the stove
off using the procedure described in par. 9.3.
In the event of stove malfunctions due to À ues with
incorrect draught, clean the À ue according to the
procedure described in par. 15.4.
The flue must be cleaned as described in
paragraph 15.4.
Do not touch the painted parts during operation
to avoid damaging the paintwork.
- cod. 004770810 - 09/2011 - Palazzetti - PN - Italy

Publicidad

Tabla de contenido
loading

Tabla de contenido