Stove Operation; Switching Off - Palazzetti ECOFIRE Manual De Instalación, Uso Y Mantenimiento

9 STOVE OPERATION

9.1 STARTING THE STOVE
To start the stove hold the * button for several
seconds.
The display shows the message "AWAITING
FLAME". This stage of operation is automatic and
managed completely by the stove itself. During this
stage the À ame will be ignited and the stove will
reach steady operating conditions.
Subsequently, the display will show the message
"FLAME ON".
The stove will then automatically switch to the
"FIRE ON" stage when the temperature is suf¿ cient
for correct operation (using the same operating
parameters as when the stove was last started).
Automatic stove ignition: the stove comes with an
automatic device that starts the pellet stove without
using other traditional ¿ re lighters.
Avoid lighting the À ame manually if the stove's
automatic ignition system is not working correctly.
When the stove is started the ¿ rst time, unpleasant
odours or smoke may be generated, caused by
evaporation or drying of certain materials used.
This phenomenon will gradually disappear.
The room should be well ventilated when starting
the stove the ¿ rst few times.
9.2 MODIFYING THE PARAMETERS
The stove operating parameters, described in
paragraph 7.2, can be modi¿ ed by the user in
two different ways based on the type of interface
selected (scrolling or compressed).
SCROLLING MENU
With this interface con¿ guration, the parameters are
shown cyclically on the display. When needing to
modify a value, wait for the desired parameter to be
displayed (Power, Fan, Set Room T.) and use the
button to increase the value or the
decrease it.
COMPRESSED MENU
When the stove is in the "FIRE ON" stage (shown
on the first row of the display), to modify the
parameters simply press the
the menu for modifying the parameters, Fig. 9.1.
The display will show the parameters (P, F, T) and
four symbols indicating the functions of the menu
buttons (OK, X, +, -).
To move from one parameter to the next press
("OK"). The selected parameter will À ash, then to
modify the value press
Once all the parameters have been set, press
("X") to exit the menu.
To modify the parameters on the compressed menu
when not in the "FIRE ON" stage, ¿ rst access the
"OPERATING SETTINGS MENU" as illustrated in
paragraph 11.1.
INSTALLATION MANUAL
USE AND & MAINTENANCE
button to
button to access
("+") or ("-").
OFF
- cod. 004770810 - 09/2011 - Palazzetti - PN - Italy
The values set will be retained until next
modi¿ ed, even when the stove is switched
off or unplugged from the power supply.

9.3 SWITCHING OFF

To switch the stove off hold the
seconds. The display will show the message "FINAL
CLEANING" and the stove will activate, for a few
minutes, an automatic procedure to shut down in
complete safety.
To start the stove again it's recommended to wait
for the stove to cool down completely.
If attempting to start the stove again the display may
show the message "WAIT TO END CLEANING",
asking the user to wait until the stove has shut down
completely.
The stove should only be switched off following the
procedure described above. Never switch the stove
off by unplugging it from the power supply.
9.3.1 Empty burn pot warning
The purpose of this warning is to ensure that the
burn pot is clean before ignition and consequently
guarantee the best possible stove operation.
Never pour the contents of the burn pot into the
pellet hopper.
After having cleaned the burn pot reset the warning
by pressing and holding the
button for a few
OFF
button.
OFF
Fig. 9.1
47/144