Alesis MULTIMIX 6 CUE Guida Rapida página 4

13
14
13. Fuse holder
14. Power Input- Connect the AC power cable to the unit and an AC power socket.
15. Main input connectors- Balanced 1/4" TRS and XLR connectors used to input the stereo signal
16. Main output connectors- Balanced 1/4" TRS and XLR connectors used to output the main
signal. Use these connectors to link several headphone amplifiers together
17. Headphone out 1-6- Sends the same signal as the headphone outputs on the front panel
APPLICATIONS
Headphone Amplifier
1. Send the signal through the Direct input or rear panel Main inputs
2. Ensure the Balanced control is fully counter-clockwise and adjust the input gain control for each of
the headphone outputs being used
3. Use the individual output gain controls to set the desired channel volume
4. Connect the headphone(s) to the headphone output(s)
5. Link as many Multimix 6 Cue mixers together via the Main outs
Independent Power Amplifiers
1. Turn the Balanced controls fully clockwise to the AUX position.
2. The Main input signal will be muted and only signals coming from the Aux inputs are routed to the
headphone outs
3. Up to six independent stereo signals can be sent through the MULTIMIX 6 CUE to provide
individual monitoring for up to six musicians
Studio Application
To mix one source with another, such as an instrumental track with a vocalist, route the instrumental
track through the Direct or Main inputs and route the vocal signal through an Aux input. Adjust the
blend of the signals using the Balanced control and monitor the combined signal through the
headphone outputs.
Mono/Stereo Application
Switch between mono and stereo operational modes via Mode switch. In mono application (Mode
switch pressed down), the two input signals are combined together and the resulting mono signal
routes to the left and right headphone outputs.
17
4
16
Rear Panel
15