Pre-Installation Checklist; Before You Begin - GE PHP9030DJBB Instrucciones De Instalación

PRE-INSTALLATION CHECKLIST

BEFORE YOU BEGIN

WARNING
The electrical power to the cooktop
supply line must be shut off while connections are
being made. Failure to do so could result in serious
injury or death.
A
When preparing the cooktop opening, make sure
the inside of the cabinet and the cooktop do not
interfere with each other. (See section on
preparing the opening.)
B
Remove packaging materials and literature
package from the cooktop before beginning
installation.
C
Be sure to place all literature, Owner's Manual,
Installations Instructions, etc. in a safe place for
future reference.
D
Make sure you have all the tools and materials
you need before starting the installation of the
cooktop.
E
Your home must provide the adequate electrical
service needed to safely and properly use your
cooktop. (Refer to section on electrical
requirements.)
F
When installing your cooktop in your home,
make sure all local codes and ordinances are
followed exactly as stated.
G
Make sure the wall coverings, countertop and
cabinets around the cooktop can withstand heat
(up to 200°F) generated by the cooktop.
31-2000021-1
Installation Instructions
H
Installing cooktop in combination with other
products. Both products must be installed
according to their specific product installation
instructions. Consideration must be given to the
separate electrical requirements and locations:
Over one or two wall ovens:
• Only certain models may be installed over
wall ovens. The wall oven and cooktop will
both have a label stating which models are
approved in combination.
Over a Microwave:
• See microwave installation instructions for
how to install a microwave under a cooktop.
For vertical dimension of cooktop, see
Approximate Cooktop Dimensions section.
In combination with telescopic downdraft vent:
• See telescopic downdraft vent instructions for
how to install a vent behind a cooktop.
• The countertop must have a deep flat surface
to accommodate the combined installation of
the cooktop and vent.
• Allow 12" clearance between the inlet air ports
on the bottom of the unit.
Over a warming drawer:
• See warming drawer instructions for how to
install a warming drawer under a cooktop.
For vertical dimension of cooktop, see
Approximate Cooktop Dimensions section.
I
Monogram Flush Mount Kit
• If you intend to mount your cooktop flush
to the counter, please order kit number
JXFLUSH1. The flush mount kit provides
supplemental cut-out instructions to mount the
product flush with the counter.
3