Care & Cleaning
Remove the power cord from the power outlet
after use for safety reasons.
Processing bowl and lid
Due to the interlock components, we do not
recommend immersing the bowl in water for
long periods.
To keep your bowl and lid clean, and to avoid
food drying on, follow these steps as soon
as possible after use:
• Rinse most of the ingredients off the bowl
and lid.
• Hand wash in clean warm, soapy water using
a mild liquid detergent and non-abrasive sponge.
• The processing bowl and lid may occasionally
be washed in the dishwasher (top shelf only),
however washing in the dishwasher is not
recommended on a regular basis, as prolonged
exposure to harsh detergents, hot water and
pressure will damage and shorten the life of the
plastic and the interlock components.
Geared spindle and Food Pushers
• The large food pusher and geared spindle should
only be hand-washed. Do not place them into the
dishwasher. Washing the geared spindle in the
dishwasher will damage the spindle.
WARNING
Do not touch
the blades of the
Dicing Grid. They
are extremely sharp.
Blades and discs
• Blades and discs are razor sharp, do not touch.
Always use a spatula or brush to remove food
or when cleaning blades.
• Disc spindle, blades and discs can be washed
in the dishwasher.
Dicer
Use the dicer cleaning cap to clear out excess
food built up in the dicing grid after EACH USE
or each 10 cups.
• Straight after dicing, remove the dicing disc
from the bowl while leaving the dicing grid inside
the bowl.
• Attach the cleaning cap to the bottom of the
large pusher.
• Align the markings on the cleaning cap with the
markings on the dicing grid, push down to clear
out the food in the grid.
• Repeat four times going around the grid until the
entire grid is cleared.
EN
19