Solo 425 Manual Del Usario página 9

12. MAINTENANCE AND CARE
- The SOLO Backpack Sprayer is almost maintenance free.
If the tank lid becomes hard to tighten or open, apply all
to the lid gasket.
- Proper Maintenance also includes:
- Regular check of the spray tank
- Regular check of spray line and screw connectors
- Clean all filters and check for any damage
- To protect piston, cylinder and piston collar (models
425/435/ 473P) from impurities in the spray solution, an
additional filter is fitted on the inlet side of the pressure
tank. This filter can be cleaned by vigorously shaking the
tank when flushing it.
With models 425/435/473P:
- After disassembly of pump components or after
replacing the piston collar, use water resistant grease to
lubricate the piston and the collar.
- In case of unexpected problems please refer to your
SOLO Dealer.
13. STORAGE
Even through the tank is manufactured from UV-stabi-
lized material we recommend that the unit is protected
from direct sunlight and stored in a dry room, away from
children and animals.
In areas subject to frost, always drain all the liquid from
tank, pressure tank and hoses.
Please always use SOLO Original Replacement Parts
available from your SOLO Partner.
WOrKSHOP SErVICE, rEPLaCEmENT
ParTS aND GUaraNTEE
maintenance and repair:
Maintenance and repair of modern motorized devices,
as well as their safety-relevant assemblies, require quali-
fied, specialized training and a workshop equipped with
special tools and test devices.
Thus SOLO recommends that you have a specialized
SOLO workshop carry out all work that is not described
in these operating instructions. Your SOLO specialist has
the required training, experience, and equipment at
his disposal to provide you with the most cost-effective
solution and can help you in many ways with advice and
service.
replacement parts:
Dependable operation and the safety of your device also
depend on the quality of the replacement parts that you
use. Use only original SOLO replacement parts.
Only original parts come from the production of the
device and thus guarantee the highest possible material
quality, dimensional accuracy, function, and safety. Origi-
nal replacement parts and accessory parts are available
from your dealer. He also maintains the requisite replace-
ment part lists to determine the required replacement
part numbers, and he is constantly provided with infor-
mation concerning detail improvements and innovations
in the replacement part offering.
Please note as well that guarantee performances from
SOLO are not possible if parts other than SOLO original
parts are used.
Guarantee:
SOLO guarantees problem-free quality and will assume
the costs for defect remediation by replacing the de-
fective parts in the case of material or manufacturing
defects that occur within the guarantee period after the
date of purchase.
Please note that specific guarantee conditions apply in
some countries. Ask your sales person if you have any
questions. As vendor of the products he is responsible for
the guarantee.
We request your understanding that no guarantee can
be assumed for damages due to the following:
• Non-compliance with the operating instructions.
• Neglecting required maintenance and repair work.
• Normal wear and tear.
• Using non-approved cutting bar and chain lengths in
the case.
• Damages caused by overheating due to dirt build up on
the ventilator casing.
• Intervention by non-specialized persons, or improper
repair attempts.
• Using unsuitable fuel or fuel that has been stored too
long.
• Damages that can be traced to implementation condi-
tions from the rental business.
Cleaning, care, and adjustment work are not recognized
as guarantee performances. All guarantee work must be
carried out by a SOLO dealer.