Health O Meter 402KL Instrucciones Para El Usuario página 6

402KL ASSEMBLY INSTRUCTIONS (CONTINUED)
Assembling the 402KL Scale (Refer to Figures 1 - 6 on pages 7- 9)
Caution: It is recommended that the assembly be performed by two persons.
1. Carefully remove the scale platform and pillar from the carton. Place the scale platform and
pillar on a flat, level, and dry surface. Using a table can be helpful for assembly of 402KL
scale (see Figures 1 & 5 on pages 7 & 9).
2. Remove the four pillar nuts and wrench from the carton.
3. Locate the steel rod at the base of the pillar (see Figures 4, 5 & 6 on pages 8 & 9).
4. Cut the tie wrap that holds the steel rod to the pillar studs (see Figure 3 on page 8).
5. Insert studs into the four holes provided in the scale platform (See Figure 2 on page 7).
6. Tip the scale platform at an angle, resting the top of the pillar on any convenient support.
Using the wrench provided, secure the pillar to the scale platform with the four nuts (see
Figures 4 & 5 on pages 8 & 9).
7. Pull the steel rod toward the base of the scale platform by grasping the finger pull loop on the
steel rod end (see Figures 4, 5 & 6 on pages 8 & 9).
8. Push the lever extension toward the pillar with your hand (see Figure 4, 5 & 6 on pages 8 &
9).
9. While holding this position, hook the steel rod to the hole at the end of the lever extension.
Release the finger pull loop and ensure that the steel rod and lever extension is hooked
together.
10. Carefully position the scale to its upright position.
11. The scale is now assembled and is ready for use (see Figure 1 on page 7).
Note: To transport your scale, acquire the optional wheel bracket (Part Number # 55000). Please
refer to the "Transportation" section for assembly instruction.
Note: To increase your scale's capacity, acquire the optional counterweight set (Part Number
# 55090). Please refer to the "Counterweights" section for user instruction.
6