General - Olsberg Orayonne Instrucciones

Fig.1: Inside of appliance housing

General

Olsberg glass radiation heaters are direct heaters for a wide range of applications. Their key features
are the elegant design, easy operation, high reliability and maximum radiation performance at minimum
convection.
Please read all the information contained in this manual carefully. The manual contains important
information on safety, installation, use and maintenance of the equipment.
The manufacturer shall not be liable for damage caused by non-adherence to the instructions below.
The heater must not be used improperly, i.e. for purposes other than the intended.
The packaging of your Olsberg appliance has been limited to a minimum and, on principle, consists of
recyclables.
Caution: While the glass radiation heater is in operation, its surfaces become very hot. Contact may
cause injury from burns. Please always ensure that children and frail persons are not left unsupervised
near the heater.
20
Warning: Do not cover the glass surface as this could lead to overheating!
Even partial covering of the glass panel, for example with a hand towel, can
cause the appliance to overheat and the heating conductor to become
damaged.
Item 1, Glass radiation heater
Item 2, Fixing hooks
Item 3, Upper securing tabs
Item 4, Wall bracket
Item 5, Plug connector
Item 6, Foam block
Item 7, Lower securing tabs