Spare Parts; Accessories; Rear Panel Hiders - Olsberg Orayonne Instrucciones

Spare parts

Please ask your specialist dealer for any spare parts required. Only original spare parts may be used.
The appliance must be installed by qualified fitters. In order to deal with your enquiry as quickly as
possible, we will need the model and serial number specified on your rating plate. You will find the rating
plate at the top or the left of the appliance.
So that you have the numbers on the rating plate to hand, we recommend entering them here before
fitting.
Model number:
Serial number:

Accessories

Rear panel hiders

For 15/2251: parts no.: 15/2251.9280
For 15/2261: parts no.: 15/2261.9280
For 15/2271: parts no.: 15/2271.9280
For 15/2281: parts no.: 15/2281.9280
The rear panel hiders are used to seal the gap between the rear panel of the appliance and the wall or
ceiling of the room. They are coated in the same colour as the appliance and can be slid onto the rear
panel of the heater. The accessory kit includes four hiders. For wall installation, only three hiders are
required (left, right and top). For ceiling installation, you must install all four hiders.
The wireless room thermostat described in chapter "Room thermostat" cannot be used in conjunction
with the rear panel hider accessory.
Installation:
Before mounting the glass radiation heaters on the wall bracket, attach the holders for the rear panel
hiders. The holders consist of the enclosed sleeves and M5x16 screws. Insert two screws with sleeves
in the threaded holes on each side of the heater rear panel and tighten by hand. These screws are
used at a later stage to secure the hider. The disk of the sleeve must be placed below the screw head
(see figure 8).
Sleeve
M5x16 screw
___________________
___________________
Fig.8
For 15/2351: parts no.: 15/2351.9280
For 15/2361: parts no.: 15/2361.9280
For 15/2371: parts no.: 15/2371.9280
For 15/2381: parts no.: 15/2381.9280
33