Safety Information; Important Safety Instructions - GE GXK185KBL Manual Del Propietario E Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING
To reduce the risk of fire, explosion, electric shock, or injury when using your
WARNING
system follow these basic safety precautions:
To reduce the risk associated with choking, do not
n
allow children under 3 years of age to have access to
small parts during the installation of this product.
To reduce the risk associated with the ingestion
n
of contaminants, do not use with water that is
microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
To reduce the risk associated with hazardous voltage
n
due to an installer drilling through existing electric
wiring or water pipes in the area of installation, do not
CAUTION
To reduce the risk of injury when using your system follow these basic safety precautions.
To reduce the risk of physical injury, depressurize system as shown in manual prior to cartridge removal.
n
NOTICE:
Read and follow Use Instructions before installation and
n
use of this system.
Installation and use MUST comply with all state and
n
local plumbing codes.
Do not use on a hot water supply (100°F max.). Install
n
on a cold water line only.
Protect from freezing, remove filter cartridge when
n
temperatures are expected to drop below 35° F (1.7° C).
Do not install if water pressure exceeds 125psi (8.8 Kg/
n
cm
). If your water pressure exceeds 80 psi (5.6 Kg/
2
cm
), you must install a pressure limiting valve. Contact
2
a plumbing professional if you are uncertain how to
check your water pressure.
Do not install systems in areas where ambient
n
temperatures may go above 110° F (43.3° C).
The disposable filter cartridge should be replaced every
n
6 months, at the rated capacity or sooner if a noticeable
reduction in flow rate occurs.
Where a back flow prevention device is installed on a
n
water system, a device for controlling pressure due to
thermal expansion must be installed.
49-6000061

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS
install near electric wiring or piping which may be in
path of a drilling tool when selecting the position to
mount the system bracket.
If this device is not maintained and operated as
n
specified in the owner's manual, there is a risk of
exposure to contaminants. For more information,
visit the manufacturer's internet website at www.
geappliances.com or the California State Water
Resources Control Boards' internet website at www.
waterboards.ca.gov.
Do not install where water hammer conditions may
n
occur. If water hammer conditions exist you must
install a water hammer arrester. Contact a plumbing
professional if you are uncertain how to check for this
condition.
Ensure all tubing and fittings are secure and free of
n
leaks.
On plastic fittings, never use pipe sealant or pipe
n
dope. Use PTFE thread tape only as pipe dope may
deteriorate the plastic.
Do not use a torch or other high temperature sources
n
near system, cartridges, plastic fittings or plastic
plumbing.
Do not install in direct sunlight or outdoors.
n
Do not install near water pipes which will be in path of
n
a drilling tool when selecting the position to mount the
bracket.
Mount system in such a position as to prevent it
n
from being struck by other items used in the area of
installation.
Ensure that the location and fasteners will support the
n
weight of the system when installed and full of water.
3

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido