Telstar THE072320MD Manual De Instrucciones página 43

Change the power cord
Position A show the terminal box position on the back of the back outer case and it's closed.
Steps: a. cut o the power, use small flat screwdriver to open two snap 1,2.
b. use Phillips crewdriver to take o screws 3,4, 5 and 6.
c. change the new power cord ,fix the yellow/green wire on 3, brother wire on 4, blue wire on 5.
d. twist screw 6 closed the terminal box cover finish the changing.
CURE YOUR APPLIANCE WHEN NEEDED
If a fault occurs, before calling the after-sales service, please ensure that is not because of incorrect opera-
tions and refer to the fault table, attempt to correct the fault yourself. You can often easily rectify technical
faults on the appliance yourself.
If a dish does not turn out exactly as you wanted, you can find many tips and instruc-tions for preparation at
the end of the operating manual.
43
BUILD IN OVEN
THE072320MD