Procom QEB100 Manual De Usuario página 5

WARNING: Before installing
the blower, be certain to turn off
the unit, and allow time for unit
to cool down.
1. Unscrew and remove top cover of the
fireplace (see Figure 1).
Figure 1 - Remove Fireplace Top Cover
2. Attach the power cord to the fireplace top
cover with 3) M4.2X8 screws (AA) (see
Figure 2).
Figure 2 - Installing Power Cord
3. Attach the blower assembly to the top
cover with 4) M4.2X8 screws (CC) (see
Figure 3).
Figure 3 - Attaching Blower to Top Cover
200070-01A
INSTALLATION - ED SERIES
AA
CC
www.usaprocom.com
4. Attach the grounding terminal to top cover
with 1) M4.2X8 screw (AA). Refer to wiring
diagram, page 15. Be sure to insert the
gasket between the protection tab and
the grounding terminal (see Figure 4).
AA
Grounding
Terminal
Gasket
Protection Tab
Figure 4 - Installing Grounding Terminal
to Top Cover
5. Insert the blower connector (male port)
into the female port on the wire connector.
This protects the jacket in the fireplace
(see Figure 5).
Male Port
Female
Port
Figure 5 - Connecting Blower Wire to
Wire Connector
5