Procom QEB100 Manual De Usuario página 6

6. Insert the female port, which is on the
white power supply wire (marked with P1),
into the corresponding male port (marked
with P1), (see Figure 6).
Figure 6 - Connecting P1 Wires
7. Insert the male port, which is on the black
power supply wire (marked with P2), into
the corresponding female port (marked
with P2), (see Figure 7).
Figure 7 - Connecting P2 Wires
8. Bundle the wiring with the cable tie (BB).
Attach cable tie to the top panel through
the hole as shown in Figure 8. This is to
avoid any heat damage to the insulation
board.
Install End of Cable
Tie Through Hole
BB
Figure 8 - Securing Blower Wires
6
INSTALLATION - ED SERIES
www.usaprocom.com
9. Attach temperature sensor to the back of
the firebox with 2) M4.2X8 screws (AA)
(see Figure 9).
Temperature
Sensor
AA
Figure 9 - Installing Temperature Sensor
10. Insert the wires marked with AUTO, OFF
and MAN into wire slot in the right corner.
Feed them as close to the bottom of the
firebox as possible (see Figure 10).
Figure 10 - Feeding Wire Harness
11. Connect two black and yellow wires (fe-
male ports) marked T1 and T2 with the
two male ports on the temperature sensor
(see Figure 11).
Temperature
Sensor
Figure 11 - Temperature Sensor Wires
MAN
OFF
AUTO
200070-01A