Changing The Channel - NEC MULTEOS M40 Manual De Instrucciones

13) REMOTE ID
Activates REMOTE ID function. See page 15.
14) GUIDE
Enter on screen program guide.
15) AUDIO INPUT
Select the Audio source.
NOTE: It is possible to play audio from a source that is
different from the video source. When setting parental
controls for video, be aware that this content is not
filtered.
16) SOUND
Artificial surround sound.
17) ENTER
Go to channel selected.
18) MENU
Turns ON/OFF menu mode.
19) SET
Makes selection.
20) - , +
Increases or decreases adjustment.
Moves the PIP sub-picture
21) EXIT
Goes to previous menu.
22) Channel
Go up or down channel selections.
23) MUTE
Mutes audio output.
24)
Activates closed captioning.
25) SLEEP
Sleep timer.
26) MTS
Multi-track sound.
Denotes AV unit function. All AV functions are enabled with the AV
unit is installed. Not all models have the AV unit installed.
Denotes Digital Tuner function. All DTV and AV functions are en-
abled when the DTV unit is installed. Not all models will have the
digital tuner installed.
Part Names and Functions
.
English-13

Changing the channel

Both Analog and Digital channels are available using this
tuner. In addition to the CH+ and CH- buttons channels can
be changed in the following method.
Tuning Analog Channels
Input the desired channel number using the keypad, then
press [SET] or [ENT] to immediately tune to the new
channel. If the number is input and [SET] or [ENT] is not
pushed, after a few seconds the channel will be changed. For
example to tune to channel 5, press [5] then press [SET] or
[ENT].
Tuning Digital Channels
To tune in to a digital sub-channel enter the number of the
main channel, then a dash followed by the number of the
sub-channel. For example to tune to digital channel 5-1,
press [5] then [–] then [1]. Press [SET] or [ENT] to tune.
- continued