NEC MULTEOS M40 Manual De Instrucciones página 36

OSD Controls
DVI MODE
SCAN CONVERSION
All inputs except for VGA,
RGB/ HV
PROGRESSIVE
INTERLACE
SCART MODE
S-VIDEO MODE
PRIORITY
SEPARATE
COLOR SYSTEM
VIDEO input only
AUTO
NTSC
PAL
SECAM
4.43NTSC
PAL-60
SCAN MODE
HDMI, DVD/HD, VIDEO, TV
input only
OVER SCAN
UNDER SCAN
ADVANCED OPTION
RESET
FACTORY RESET
- continued
Adjusts the phase of the red signal.
RED DELAY
Adjusts the phase of the green signal.
GREEN DELAY
Adjusts the phase of the blue signal.
BLUE DELAY
Adjusts the performance degradation of the RED signal.
RED SHARPNESS
Adjusts the performance degradation of the GREEN signal.
GREEN SHARPNESS
Adjusts the performance degradation of the BLUE signal.
BLUE SHARPNESS
Adjusts the shape of Sync on Green signal.
SOG PEAK.
Optimize the shape (Tailing) of RED, GREEN and BLUE signals.
VIDEO EQ.
RGB/HV input only
Selects the terminate resistance for matching the cable impedance.
SYNC TERMINATE
RGB/HV input only
Choose the DVI mode based on the input device connected via DVI connector.
When a PC or similar equipment is connected.
DVI-PC
When a DVD player is connected.
DVI-HD
Selects the IP (Interlace to Progressive) conversion function.
Note: For DVI input "DVI-HD" needs to be enabled in the DVI mode.
Converts interlaced signals to progressive.
This is the default setting.
Disables IP conversion. This setting is best suited for motion pictures, but increases the
risk of image retention.
Input mode for devices using SCART connectors.
Selects the S-Video input port function.
When an S-Video cable is connected to the S-Video input, it will have priority over
the composite input port.
The S-Video port and Composite port can be selected as independent input ports.
The selected Color System depends on the video format of the input signal.
Automatically chooses Color System setting based on input signal.
Some video formats may require different scanning modes in order to best display the im-
age.
Image size is larger than what can be displayed. The image edge will appear cropped.
Approximately 95% of the image will be shown on the screen
Image size stays within the display area. The whole image is displayed on the screen.
Resets the following settings within the ADVANCED OPTION menu back to factory set-
ting: INPUT DETECT, LONG CABLE ON/OFF, LONG CABLE MANUAL, DVI MODE, SCAN CONVER-
SION, S-VIDEO MODE, SCAN MODE.
Resets OSD options back to factory settings EXCEPT FOR: CHANGE SECURITY PASS-
WORD and SECURITY PASSWORD.
English-32