Chemfree SmartWasher SW-05 Manual De Operación página 5

OzzyJuice
The SmartWasher uses a specially
formulated fluid which provides a
combination of excellent cleaning
characteristics, safety and nutrition for
the Ozzy microbes. OzzyJuice is
provided in ready-to-use containers.
DO NOT ADD WATER, SOLVENT,
MINERAL SPIRITS, GASOLINE OR
KEROSENE TO YOUR SMARTWASHER!
To help monitor and maintain the proper
fluid level, the SmartWasher is equipped
with a low fluid level indicator. When the
"Add Fluid" light comes on, add a 5
gallon box of OzzyJuice immediately.
When a container of OzzyJuice is added
the light will go out. When the "Add
Fluid" light comes on the heater will
turn off until the necessary amount of
fluid is added.
Remember, the OzzyMat needs to be
replaced every 30 days.
To Add OzzyJuice
Slowly pour a full container of OzzyJuice directly into
the SmartWasher sink. The "Add Fluid" light should go
out.
If you add a container of OzzyJuice to your machine
and the "Add Fluid" light is still on, lift up on the sink
and check to see if the float is in the down position. If
the fluid is below the float and the float is not at the
top stop, you will need to add more fluid. If the fluid is
over the float, there may be a problem with the low
fluid indicator and you should call your service
representative.
2
Add Fluid
light
ChemFree Technical Support • 1-800-521-7182
Temperature
Your SmartWasher should be plugged in 24 hours a day, 7
days a week to maintain optimal temperature.
The thermostat is factory-set to maintain fluid temperature
at 105°F (+-5°) (40°C) (+-3°). This temperature provides
the optimum condition for effective cleaning and activity of
Ozzy microbes.
The heater will not operate when the fluid level becomes
critically low. Lift the sink up and check your fluid level.
Your SmartWasher should have approximately 8" of fluid
in it. If the fluid lever is lower than that, add OzzyJuice. If,
after a reasonable warm-up period, the fluid temperature
seems too hot or too cold, please refer to the
"Troubleshooting" section on page 5.
If the temperature falls below the recommended minimum,
the system will still clean, but remediation of the
hydrocarbons by the Ozzy microbe colony will slow down
but the microbes will not die. The Ozzy colony will
become more active when the fluid temperature reaches
the appropriate level.
PROPER USE AND CARE OF THE
SMARTWASHER
To keep your new system operating at its best, please
remember these important hints:
• The heater is disabled as long as the "Add Fluid" light
is on.
• The SmartWasher is designed to "eat" the oil and
grease washed from dirty parts. It is NOT designed to
function as a waste-oil dump! The Ozzy microbes will
thrive on oil and grease washed from parts during
normal use. If excessive oil, gasoline, transmission
fluid, antifreeze or similar fluid is dumped into the
system, the Ozzy microbes may be destroyed.
• DO NOT ADD - water, bleach, disinfectants,
insecticides or biocides of any description.
• Change the OzzyMat every month.
• To maintain the effectiveness of the SmartWasher it is
imperative that nothing be added to OzzyJuice other
than replacement OzzyJuice, or dirty parts residue.
• Turn off pump when not actually washing parts. This
will help to decrease fluid evaporation.
• Do not clean paint brushes in the SmartWasher;
OzzyMicrobes will not consume the inorganic pigments
in paint.