Monitor Audio TRIMLESS Serie Manual De Instalación página 3

Fitting the custom install loudspeakers
draw around template and mark centre
1
lines if necessary
c u t o u t t e m p l a t e
Diameter: 170mm (6 11/16")
How to use this template:
1) Remove the Protective backing from the "low tack"
adhesive tape on rear of this template.
2) Align centre lines.
Template
3) The outside profile is an accurate indication of the speaker box hole required.
4) Draw around the profile, remove template and cut hole.
5) The template can be repositioned a number of times if required.
connect speaker cables by pushing
3
down on the terminals and clamping the
bare wire in the through hole.
tighten tri-grip screws.
5
see over tightening warning.
cut around marked line
2
4
guide speaker into cut out
Fit grilles. they are held in place
6
magnetically and should 'snap' into
place.