Emptying The Drum; Blowing Feature - Emerson Workshop WS1600VA0 Manual Del Usuario

emptying the Drum

WARNING: To reduce the risk of
injury from accidental starting,
unplug power cord before emptying
the drum.
1. The Vac comes equipped with a Drain
for easy emptying of liquids. Simply
unscrew the Drain Cap and lift the
opposite side slightly to empty the
Drum.
2. Another option is to remove the
Powerhead Assembly. Pull the Flexible
Latches outward on each side of the
Powerhead Assembly to release from
the Drum.
3. While holding the Latches out, lift the
Powerhead Assembly up and away
from the Drum.
4. Lay Powerhead Assembly upside
down on a clean area while emptying
drum or changing Filter.
5. Dump the Drum contents into the
proper waste disposal container.
WARNING: To reduce the risk of
back injury or falls, do not lift a vac
heavy with liquid or debris. scoop
or drain enough contents out to
make the vac light enough to lift
comfortably.
WARNING: To reduce the risk of
electric shock or fire, unplug vac
when not in use. Never leave
running while unattended.
oPeRATIoN (continued)

blowing feature

Your Wet/Dry Vac features "Full Blowing".
It can blow sawdust and other debris.
Follow the steps below to use your Vac
as a Blower.
WARNING: Always wear safety
eyewear complying with ANsI Z87.1
(or in canada, csA Z94.3) before
using as a blower.
WARNING: To reduce the risk of
injury to bystanders, keep them
clear of blowing debris.
cAuTIoN: Wear a dust mask if
blowing creates dust which might
be inhaled.
cAuTIoN: To reduce the risk of
hearing damage, wear ear protectors
when using the vac/blower for
extended time or in a noisy area.
1. Locate Blowing Port of your Wet/Dry
Vac.
2. Insert the tabbed end of Hose into the
Blowing Port of the Vac.
3. (Optional) Attach Extension Wand to
Swivel End of Hose, then place a Car
Nozzle on the Wand.
4. Turn Vac on and you are ready to use
your Vac as a Blower.
Blowing Port
Dual-Flex
Locking
Hose
10