Sennheiser RS 2400 Instruciones Para El Uso página 20

WHAT TO DO IF ...
... the volume is up but you
cannot hear anything:
... the sound is distorted:
... the sound is slightly noisy:
... you can hear twittering and
chirping, and the sound is "squeezed":
... the transmitter switches off
during operation:
ACCESSORIES
BA 151 Rechargeable accupack as a spare, for use when the supplied
accupack is being recharged.
L 151-2 Charger for recharging two BA 151 accupacks (recommended
when more than two stethoset receivers are used with one
transmitter).
RR 2400-8 Additional stethoset receiver
There is no audio signal available. Check the transmitter
connection. Is the volume at the headphone socket of your
sound source sufficient?
Are you still within the transmitter's range?
Is the receiver on the same frequency as the transmitter?
The receiver accupack has gone flat, please
recharge it immediately.
The volume on the receiver is adjusted too high.
Reduce the volume.
You are about to leave the transmitter's maximum range.
Soon transmission will be interrupted completely.
The transmitter's modulation level is too low.
Increase the volume on your sound source.
Two transmitters are interfering!
Choose a different transmission channel.
The volume on your TV set is adjusted too low. Adjust
the volume on the TV set such that the LED on the
transmitter blinks occasionally.