FRICON SMR Serie Uso Y Mantenimiento página 37

SMR
CAUTION
The use of gloves is required during cleaning. The sharp extremities of the
equipment may cause cuts on hands.
Cleaning the Interior:
• Remove all products from inside the appliance.
• Disconnect the equipment from the electrical current for the time needed to
defrost the appliance walls completely.
• Clean the equipment with a soft cloth upon defrosting.
• Wash the interior with pure water, to which a little neutral detergent may be
added.
• Dry with a soft cloth.
• Connect and wait for the appliance to reach operational temperature once
again.
• Place the products inside.
Cleaning the Exterior:
• Clean the equipment's exterior with a soft sponge soaked in warm water and
soap.
• Then clean with a soft cloth and dry.
• The refrigerator circuit's exterior (compressor, condenser, connection tubes,
and remaining components) must be cleaned with a soft brush or vacuum
cleaner.
• Pay special attention while cleaning the condenser. If obstructed, it will affect
the equipment's performance.
• While cleaning, be careful not to twist the tubes or disconnect cords.
Cleaning Glass Lids:
• Cleaning with cloth with abrasive microfibers and all types of coarse sponges
is prohibited.
• Make sure that large quantities of water are not applied on the glass surfaces
to be cleaned and that the surfaces are thoroughly dry afterward.
36
English