Operation With Remote Controller - Klarstein Windwalker Manual De Instrucciones

Note:
- With Anti-F activated, it is advised not to turn ON the appliance again before it is
fully OFF.
- Anti-F function will be invalid when OFF timer is set.
15.­ELE.H/ECO­
This button has two function:
a)­ELE.H­(Electric­Heating)
• If this button is pressed in HEAT mode, the electric heating will be turned on/off.
b) ECO (Eco mode)
• If this button is pressed in COOL mode, the appliance will enter the ECO mode
which has the lowest electricity consumption, and exit it automatically 8 hours after.
• Changing modes or turning off the remote controller will automatically cancel the
ECO function.
• Press ECO button in ECO mode to exit this mode.
Note: The ECO mode only works for inverter units.

OPERATION WITH REMOTE CONTROLLER

Automatic­operation­mode­(AUTO)
1. Press the "MODE" button, select the automatic operation mode.
2. By pressing the "SPEED" button, you can select the fan speed from LOW, MID,
HIGH, AUTO.
3. Press the "ON/OFF" button, the air-conditioner starts to operate.
4. Press the "ON/OFF" button again, the air-conditioner stops.
Note: In the fan operation mode, the temperature settings is non-effective.
Cooling/Heating­operation­mode­(COOL/HEAT)
1. Press the "MODE" button, select the Cooling or Heating operation mode.
2. By pressing the or
(60 °F) to 32 °C (90 °F), the display changes as you touch the button.
3. By pressing the "SPEED" button, you can select the fan speed from LOW, MID,
HIGH, AUTO.
4. Press the "ON/OFF" button, the air-conditioner starts to operate.
button, you can set the temperature range from 16 °C
EN
79