Klarstein Windwalker Manual De Instrucciones página 78

EN
78
10.­MODE
• Press this button, you can select the running mode as follows:
Note: HEAT mode is not available for cool only appliances.
11.­SLEEP
• Press this button to enter SLEEP mode, which the appliance will exit after 10 hours of
continuous operation and restore to the previous status.
Note: The SLEEP function cannot be activated in FAN mode.
12.­SWING­
• Press this button to activate up/down swing and press it again to fix the swing
position.
13.­SWING­
• Press this button to activate left/right swing and press it again to fix the swing
position.
14.­Anti-F­(Dehumidification)
• The Anti-F functions when the appliance is turned off with the remote controller in
COOL, DRY or AUTO mode.
• It will operate in HEAT mode (FAN mode for cool only appliances), with the internal
fan running with weak flow for 3 minute before stop, to remove the moisture within
the evaporator so as to prevent it from giving off bad smell from maid.
• This function is not set in the factory. You may set it or cancel it any time you want as
follows: With both the appliance and the remote controller OFF, point the remote
controller at the appliance and press "Anti-F" button once, the buzzer will sound 5
times after 5 times, indicating this function is set. Once set, this function will remain
valid except when the appliance is power off or until it is cancelled.
To cancel Anti-F function:
1. Power off the appliance.
2. With both the appliance and the remote controller OFF, point the remote controller
at the appliance and press this button once, the buzzer will sound 3 times after
5 times, indicating this function is cancelled.