JB Systems SUPER LED RAINBOW Manual De Instrucciones página 13

ENGLISH
OPERATE THE UNIT BY CA8 OR RF8SET
When used in standalone or master/slave mode we strongly advise you
to use the CA-8 "Wired easy controller" or RF-8SET "Wireless easy
controller".
 CA-8 wired remote: Connect the controller to the jack input of
the first unit (master).
 RF-8SET wireless remote: the wireless remote has two parts:
 RF-8T: small RF-transmitter that can control up to 5 effects.
 RF-8R: small RF-receiver that should be connected to the
DIN 5pin input of the BT-60LS. See the installation manual of
the receiver for more information.
Now you can control all the connected units:
Blackout
1. Synchronous Strobe in white
Function 2. Asynchronous Strobe in white
3. Sound Strobe in color
Mode
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
 The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit's optics.
 Clean with a soft cloth using normal glass cleaning products.
 Always dry the parts carefully.
JB SYSTEMS
®
Sound/Strobe
(LED OFF)
Blackout the unit
Select Color
1. Red
2. Green
3. Blue
4. White
5. Red + Green
6. Red + Blue
7. Red + White
8. Green + Blue
9. Green + White
10. Blue + White
11. Red + Green + Blue
12. Red + Green + White
13. Red + Blue + White
14. Green + Blue + White
15. Red + Green + Blue + White
16. Color change by sound
Manual Color
(LED ON)
11/61
OPERATION MANUAL
Select Show
1-8
LED blinking
SUPER LED RAINBOW