How To Install The Rf Extender; How To Connect The Rf Extender - Philips Pronto RFX6500 Guia Del Usuario

Make sure you have the following components: RF Extender Receiver unit,
RF Extender Blaster unit, power adapter, connection cable, Dual IR emitters and
screws.
The installation of the RF Extender consists of 4 main steps:
Connecting the RF Extender;
Positioning the Blaster unit;
Installing the Dual IR emitters;
Positioning the Receiver unit.

How to Connect the RF Extender

1 Plug the power cable into the Blaster unit.
2 Plug the power adapter into the mains wall socket.
When connected, a red LED on the Blaster unit will start blinking.
After a few seconds, the LED will stop blinking and stay on.
Remark The LED on the Blaster unit will also blink when the Blaster unit sends out
3 Plug the connection cable into the Blaster unit until it clicks.
4 Plug the connection cable into the Receiver unit until it clicks.
When connected, the LED on the Receiver unit will stay on for 3 seconds.
Afterwards, the LED will go off.
User Guide
5

How to Install the RF Extender

IR signals to the audio/video devices.