Fagor STT 8000 Manual Del Usario página 17

TROUBLESHOOTING
Tab. 5
Effect
"Status" LED colour: Green
"Status" LED colour: Orange
"Status" LED colour: Red
"Comm" LED colour: Orange
TUNER UNLOCKED
PROGR M MISSING
T BLES NOT FOUND
OUT BW EXCEEDED
HW F ILLURE
NO DESCR MBLE
CI NOT PRESENT
CI W RNING
LCN REPE TED
SID REPE TED
Cause
OK.
Defective Input Signal.
Tuner not synchronized.
Output Service disappeared
from transponder.
No RF output.
Image pixilation.
Hardware failure.
Waiting control data.
Tuner unlocked.
Service not found.
Defective Input Signal.
Image pixilation.
Hardware failure.
Some active service is
chripted.
C M not detected.
C M error (initialization error or
communication error).
LCN repeated.
SID repeated.
17
ction
Check 1st IF Input Signal (level, C/N).
Check Frequency, Baud Rate, DVB mode.
Check OUTPUT SERVICES list; Read Services and
check if any program disappeared.
Check if OUTPUT RF is "YES".
Check if Output Mux BW(%) is lower than 92%.
(OUTPUT SERVICES).
Switch OFF and ON again.
Check Communication Bus between Modules and
MCU 8000. OK if there is no MCU 8000 unit.
Check 1st IF Input Signal (level, C/N).
Check Frequency, Baud Rate, DVB mode.
Read Services in OUTPUT SERVICES.
Check 1st IF Input Signal (level, C/N).
Check if Output Mux BW(%) is lower than 92%.
(OUTPUT SERVICES).
Switch OFF and ON again.
Check rights of active services.
Check C M connection.
Repeat last operation.
Check LCN repetition on active services.
Check the Service ID repetition on active services.