How To Remove And Install The Pullout Drawer - Maytag MBB1952GRQ Guía Del Usario

Installation,
How to remove and
install the pullout
drawer
(SELECT MODELS)
DANGER
To prevent accidental child entrap-
ment or suffocation risk, DO NOT
remove the divider in the top freezer
basket.
WARNING
To avoid electrical shock which can
cause severe personal injury or death,
disconnect power to refrigerator
before removing doors. After replacing
doors, connect power.
CAUTION
To avoid possible injury, product, or
property damage, you will need two
people to perform the following
instructions.
To remove:
1. Pull upper basket out to full extension
and lift out to remove.
2. Remove lower basket by pressing
inward on basket sides, then lift
basket.
Press Tab Here
5
cont.
3. Pull drawer open to full extension.
4. Remove Phillips screw from each side
of rail system. (Select models)
5. Lift top of door to unhook door sup-
ports from rail system. Lift door out to
remove.
To install:
1. Pull both rails out to full extension.
2. While supporting door, hook door sup-
ports into tabs located on inside of rail.
3. Lower door into final position.
4. With drawer pulled out to full exten-
sion, insert lower basket by aligning
tabs on both sides of lower basket with
notches in rail assembly. Verify that
the basket sides are hooked securely
over the rails.
5. Slide upper basket into freezer. Make
sure that rear of basket hooks behind
rail catch.