Kenmore 119.16144210 Manual De Uso Y Cuidado página 8

Side Burner Lighting
• Do not lean over grill while lighting.
1. Turn OFF all gas burner control valves.
2. Turn ON gas source or tank slowly.
3. Open lid and leave open during side burner lighting
and operation.
4. Turn the side burner control knob to _Hi.
Immediately press the electronic ignition button for 3
to 5 seconds. You should hear a clicking sound which
shows the electronic igniter is working.
5. Once burner has ignited, turn knob to desired heat
setting.
6. If
ignition does not occur in 5 seconds, turn the burner
control knob to OFF, wait 5 minutes for gas to clear
away, and repeat the lighting procedure.
Turn controls and gas source or tank OFF when
not in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat
the lighting procedure. If the burner does not
ignite with the valve open, gas will continue to
flow out of the burner and could accidently
ignite with risk of injury.
Match-Lighting
• Do not lean over grill while lighting.
• Open lid. Turn on gas at LP cylinder slowly.
• Light burners one at a time.
Match Lighting the Main Burners
1. Place match into match holder (hanging on inside
cabinet door).
2. Strike the match and position lit match through the
grates and hold next to the burner.
3. Push in and turn burner control knob to _Hi. Continue
to press in on the control knob until the burner ignites
or up to 5 seconds.
4. If ignition does NOT occur in 5 seconds, turn the
burner control knob OFF, wait 5 minutes for gas to
clear away, and repeat the lighting procedure.
Match Lighting the Side Burner
1. Place match into match holder (hanging on inside
cabinet door).
2. Strike the match and position lit match next to the
side burner.
3. Push in and turn side burner control knob to _Hi.
Continue to press in on the control knob until the
burner ignites or up to 5 seconds.
4. If ignition does NOT occur in 5 seconds, turn the side
burner control knob OFF, wait 5 minutes for gas to
clear away, and repeat the lighting procedure.
5. When lit, turn the side burner control knob to the
desired heat setting.
I old match down
next to burner
Match
Holder
Burner Flame Check
• Remove cooking grates and heat diffusers. Light
burners, and rotate knobs from Hi to Low. You should
see a smaller flame on Low than you see on Hi.
Perform a burner flame check on the side burner as
well (if equipped). Always check flame prior to each
use. If only low flame is seen, then refer to "Sudden
flame drop or low flame" in the Troubleshooting
Section.