Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation and programming manual
11
1
12
1
13
1
14
1
15
1
16
0
17
0
18
0
19
0
20
0
21
0
22
0
23
L
24
L
25
L
26
L
27
L
28
L
29
L
30
L
1.
Put the intrusion control panel in maintenance mode.
2.
Press button P1 to access the address setting menu. During this phase the
PRG LED will switch On and the LEDs will show the current address.
3.
Use the P2 to reach the address to be assigned.
4.
Use the P1 button to assign the address and exit the menu (phase 0).
5.
Include the wireless expansion boards in the control panel configuration,
starting from the "ADD" address (maximum "ADD" +9).
6.
Enroll the wireless reader at the "ADD" address.
Once the control panel has completed the reading procedure, go to the
programming template of the configured readers. The reader simulated by the
Air2-BS200 transceiver is the one with the "ADD" address set by the module itself.
Type-in Code (Installer PIN) , PROGRAMMING Readers , ChoosePeripheral
In the list of configured readers, the reader simulated by an Air2-BS200 has a"W"
at the end of its description.
Pressing and holding the P2 button during normal operating status of the Air2-
BS200 will allow you to view (but not change) the transceiver address indicated on
its LEDs.
1.
Go to the expansion board field and then to the terminal concerned.
2.
Configure the terminal as "Wireless":
Type in Code (Installer) , PROGRAMMING Terminals, select the terminal concerned
Press the number key
(pressing button again will disable the wireless attribute on the terminal).
Right-click and select "Wireless" (the PCB image will change to colour only after a
successful enrollment procedure of the relative devices).
If a terminal on the expansion board is configured as "wireless", all the remaining
terminals must be configured as "wireless" terminals.
3.
Enrolling the terminal:
Type in Code (Installer) , PROGRAMMING Terminals, select the terminal concerned ,
Wireless, Enroll device
Installation
Table 18: Panel notifications
0
1
1
0
1
0
1
1
1
1
0
0
0
L
0
L
L
0
L
0
L
L
L
L
0
0
0
0
0
L
0
L
L
0
L
0
L
L
L
L
; "Wireless" will appear on the last line of the display
1
0
1
0
1
L
0
L
0
L
0
L
0
L
0
L
0
L
0
L
Enrolling devices
Via software
Via keypad
4-7
Via keypad
Via software
Note
Via keypad
15
Publicidad
Tabla de contenido
