INIM Electronics Air2 Manual De Instalación Y Programación página 20

Device Terminal type
Dual technology
XDT200W
detector
Curtain detector
DT200T
Detector direction
MC300 Magnetic contact
20
Table 22: Wireless terminal parameters
SmartLiving
from 1 (least sensitive) to 15 (most
sensitive)
10 is the default value
from 1 (least sensitive) to 15 (most
sensitive)
10 is the default value
from 1 (least sensitive) to 10 (most
sensitive)
5 is the default value
from 1 (least sensitive) to 10 (most
sensitive)
5 is the default value
from 1 (least sensitive) to 15 (most
sensitive)
10 is the default value
from 1 (least sensitive) to 15 (most
sensitive)
10 is the default value
from 1 (least sensitive) to 10 (most
sensitive)
5 is the default value
from 1 (least sensitive) to 10 (most
sensitive)
5 is the default value
Selection of the magnetic reed contact
- Magnet long side - for detection on the long side of the magnetic contact.
- Magnet short side - for detection on the short side of the magnetic contact.
- Both magnets - for detection on at least one side of the magnetic contact.
Detects tamper on the Air2-MC300 magnetic-contact when both reeds are in standby
This option assures the activation/deactivation of the output within 2 seconds of the
control panel command. Valid only for terminals T1 and T2 of Air2-MC300 configured as
Parameter
Infrared detector sensitivity
from 1 (least sensitive) to 10 (most
Microwave detector sensitivity
from 1 (least sensitive) to 10 (most
Tamper detector sensitivity
from 1 (least sensitive) to 10 (most
Masking detector sensitivity
from 1 (least sensitive) to 10 (most
Infrared detector sensitivity
from 1 (least sensitive) to 10 (most
Microwave detector sensitivity
from 1 (least sensitive) to 10 (most
Tamper detector sensitivity
from 1 (least sensitive) to 10 (most
Masking detector sensitivity
from 1 (least sensitive) to 10 (most
No parameter to program
Tamper on inactive reed relay
status.
Broadcast RF
outputs.
Wireless accessories
Prime
sensitive)
6 is the default value
sensitive)
6 is the default value
sensitive)
3 is the default value
sensitive)
3 is the default value
sensitive)
6 is the default value
sensitive)
6 is the default value
sensitive)
3 is the default value
sensitive)
3 is the default value
Programming