Taurus ALPATEC AC 201 Manual Del Usuario página 12

ANOMALIES
The unit does not work
The unit does not seem to
operate
The unit is very noisy
Compressor does not
work
DETECTION CODES
E0:
E2:
FOR EU PRODUCT VERSIONS AND/OR IN
THE CASE THAT IT IS REQUESTED IN YOUR
COUNTRY:
ECOLOGY AND RECYCLABILITY OF THE
PRODUCT
- The materials of which the packaging of this
appliance consists are included in a collection,
classification and recycling system. Should you
wish to dispose of them, use the appropriate
public containers for each type of material.
- The product does not contain concentrations of
substances that could be considered harmful to
the environment
This symbol means that in case you wish
to dispose of the product once its working
life has ended, take it to an authorised
waste agent for the selective collection of
waste electrical and electronic equipment
(WEEE)
This symbol means that the product may
include a battery or batteries; the user
must remove them before disposing of
the product. Remember that batteries
must be disposed of in duly authorised contai-
ners. Do not dispose of them in fire.
CAUSES
No power supply
Water full indicator lit
Windows or doors open
Filter is very dirty
Air inlet or air outlet is blocked
Room temperature is lower
than the set temperature.
The unit is not standing on a
flat surface
Overheat safety trip has been
triggered
MEANING
Temperature sensor fault
Water tank full
This appliance complies with Directive 2014/35/
EC on Low Voltage, with Directive 2014/30/EU
on Electromagnetic Compatibility, with Directive
2011/65/EU on restrictions on the use of certain
dangerous substances in electrical and electronic
appliances and with Directive 2009/125/EC on
the ecological design requirements applicable to
products related to energy.
SOLUTIONS
Turn on the appliance
Drain out any water inside the con-
tainer
Switch the appliance on after having
drained it.
Draw the curtains
Close the windows
Clean or change the air filter
Clean the container
Change the temperature setting
Place the unit on a flat stable surface
that can support its weight
Leave it to cool down for 3 minutes
and then restart it