Assembly - Vermeiren Illico Manual De Instalación

EN
NL
4.3
PL
CS
[1]
•
Place the undercarriage with the four
wheels on a flat and level floor.
•
Apply the brake on the four castor wheels
(position B).
[3]
•
Use the handset to raise the cross of the
undercarriage to its assembly position C.
At position C, the roller shaft of the
cross is in line with the marking on the
base frame.

Assembly

B
[2]
•
Open the control box with the control-box
opener (see §4.1), by pressing the two
locking clips simultaneously.
•
Connect the handset and power-supply
cable, if not connected yet, see §4.2.
•
Unwind the power-supply cable from the
cable holder on the undercarriage frame.
•
Plug the power-supply cable in the 230V
socket.
C
[4]
•
Make sure that the cable of the handset
is on the side of the undercarriage.
•
Take the leg section (with strap) from the
transport trolley, place it on the roller
wheels
undercarriage, on the side with rollers
(19), see next picture.
Installation manual
- 12 -
2018-07
Assembly and disassembly
(18) and roll it to
Illico
18
19
the