Assembly / Disassembly Transfer Board; Use Of The Transfer Board; Mounting The Transfer Board To The Bathtub; Removing The Transfer Board From The Bathtub - Vermeiren Vera Manual De Instrucciones

6. Assembly /
transfer board
L
CAUTION: Risk of injury - Check that
the transfer board is well assembled.
Mount / remove all the components as
showed in the figure below.
Fig 2. Assembly / Disassembly transfer board

7. Use of the transfer board

The transfer board is ideal for usage in a
bathtub.
The transfer board can be mounted on the top
of the bathtub and can be easily removed
when not in use. So other persons can use
the bath.
7.1. Mounting the transfer board to the
bathtub:
Fig 3. Mounting / removing transfer board to the
bath
L
CAUTION: Risk of injury - Check that
the board is properly fixed in the
bathtub with the attachment tips .
L
CAUTION: Risk of injury - Check that
the board can rest enough on the bad
board, that the inner width of the
badtub is not too large.
L
CAUTION: Risk of injury - Be careful
you do not place your fingers, clothes
between the badtub and transfer board
when mounting the board in the bad.
1. Place the transfer board  on the bad
board.
Disassembly
7.2. Removing the transfer board from the
7.3. Turning or moving transfer board:
L
Let someone assist you for a smoothly, safely
turning of the transfer board.
3
2. Move the attachment tips  and
position these against the bad sides.
3. Check that the transfer board is
properly fixated to the bath.
bathtub:
1. Loosen the attachment tips  from the
bath.
2. Take the transfer board out the bath.
Fig 4. Turning / moving the transfer board
CAUTION: Risk of injury - Check that
the swivel disc is properly locked after
turning.
1. Pull the plastic lip out the hole.
2. Lift the legs of the patient up when
turning to the washing position.
3. Turn the swivel disc to the desired
position. The swivel disc can be locked
in four 90° positions by placing the lip in
one of the four locking holes. Move the
swivel disc in a straight direction more
to the handgrip or away from the
handgrip (range 100 mm: stepless).
4. Lock the swivel disc by placing the
swivel disc in the correct locking hole.
5. Check that the swivel disc is properly
locked.
Vera
2015-11