Instructions For Use - Tecno-gaz NEGATIVOSCOPIO Istrucciones Para El Uso

PAR. 08

INSTRUCTIONS FOR USE

7085/N negatoscope 30x40 shall be connected to a single-phase electric socket with
voltage 220V±10%, frequency 50 Hz.
The socket shall be provided with earthing protection, magneto-thermal circuit breaker
with differential (life protection).
Do not place extension, interfaces, etc. between the equipment plug and the electric
system socket, as these alterations can adversely affect equipment safety characteristics.
7085/N negatoscope 30x40 can be used on desk top or hanged on walls. On desk tops, it
rests on four rubber feet provided; to be hanged on walls, the operator shall use two wall
nogs with more than 4 kg capacity load (weight of equipment) to be fixed on the wall at
the distance between centers, as shown in fig. 04 below.
The negatoscope is provided with two holes in its lower plane with distance between
centers like those shown in the previous figure to be hanged to the nogs.
7085/N negatoscope 30x40 is provided with negative fastening systems, placed in the two
longer sides, as shown in figure 1.
Always switch off the negatoscope after use.
16
MNE0001