Technical Data - EINHELL BM 240 Manual De Instrucciones

BM 240 28.03.2003 9:02 Uhr
GB
31. Before you use the machine for the first time,
check that the voltage marked on the rating plate
is the same as your mains voltage.
32. If you use a cable reel, the complete cable has to
be pulled off the reel.
33. Persons working on the machine should not be
distracted.
34. Note the direction of rotation of the motor and
blade.
35. Never dismantle the machine's safety devices or
put them out of operation.
36. Never cut workpieces which are too small to hold
securely in your hand.
37. Never remove loose splinters, chips or jammed
pieces of wood when the saw blade is running.
38. It is imperative to observe the accident
prevention regulations in force in your area as
well as all other generally recognized rules of
safety.
39. Note the information published by your
professional associations.
40. Position the blade guard so it is approx. 3 mm
above the material you want to saw.
41. Important! Support long workpieces (e.g. with a
roller table) to prevent them sagging at the end
of a cut.
42. Make sure the blade guard (10) is in its lower
position when the saw is being transported.
43. Safety guards are not to be used to move or mis-
use the machine.
Wear safety goggles
Wear ear-muffs
Wear a breathing mask
18
Seite 18

5. Technical data

Voltage:
Power:
Ideal speed no:
Blade length:
Max. blade width:
Blade speed:
Cutting height:
Throat:
Table size: 290 x 290 mm
Tilting range of table:
Workpiece size: 1500 x 1000 mm
Weight:
Noise emission values
Cutting
Sound pressure level LPA
92.5 dB (A)
Sound power level LWA 105.5 dB (A)
6. Before putting the machine into
operation
Make sure the machine stands securely, i.e. bolt
it to a workbench or solid base. There are two
holes for this purpose in the machine foot.
All covers and safety devices have to be properly
fitted before the machine is switched on.
It must be possible for the blade to run freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machine's moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
7. Assembly
CAUTION!
Pull out the power plug before carrying out any
maintenance, resetting or assembly work on the
bandsaw!
230V~50 Hz
300 W
890 min -1
1520 mm
10 mm
672 m/min
75 mm / 90°
45 mm / 45°
230 mm
0° to 45°
13.2 kg
Idling
88.7 dB (A)
101.7 dB (A)