Installation Instructions – FFL Series Industrial LED Floodlights
Visor Installation Instructions
1.
Remove power from floodlight.
2.
Place floodlight face up.
3.
Carefully align visor with two (2) screw holes at the top
of the fixture shown in the image above.
4.
Install screws provided with visor, taking care to not
scratch the finish of the floodlight. Torque to 80 in-lbs.
5.
Install floodlight per above instructions.
N
Note:
Visor can be installed before or after floodlight has
been in operation.
Guard Installation Instructions
1.
Remove power from floodlight.
Figurt 3.
With Visor and Guard
4
Figurt 4.
With Guard Only
For
Visor
See
Note 1
Figurt 6.
Floodlight with Visor and Guard shown
InsoallaoiNn InsorucoiNns – FFL Strits Indusorial LED FlNNdlighos
IF 1629 FS
ADC140282
2.
Place floodlight face up.
3.
Carefully align guard with four (4) screw holes on each
side of the fixture shown in the image above.
4.
Install screws provided with guard taking care to not
scratch the finish of the floodlight. Torque to 80 in-lbs.
5.
Install floodlight per above instructions.
N
Note:
Guard can be installed before or after floodlight has
been in operation.
N
Note:
Visor and guard can both be used on a floodlight at
the same time. Visor and guard are always installed
in the field and are not factory installed, therefore
field installation is acceptable and will not affect the
fixture's ratings.
Figurt 5.
For
Guard
See
Note 1
www.cooperlighting.com
With Visor Only