Atlantic SOLWSL2 Manual De Operación página 2

Introduction
Thank you for purchasing Atlantic SOL Lighting. Atlantic's SOL Lighting features solid brass
bodies with an oil-rubbed bronze finish. These lights work under water and in open air
applications to give your water feature a soothing, warming glow after the sun goes down.
Multiple LEDs can be connected to be run through one transformer.
Prior to Operation and Installation
Caution:
• DO NOT operate this product under any conditions other than those for which it is
specified. Failure to observe these precautions can lead to electrical shock, product
failure, or other problems.
• Follow all aspects of electrical codes when installing SOL Lighting.
• To reduce the risk of electrical shock, connect only to a 110 volt receptacle
protected by a ground fault circuit interrupter (GFCI).
• Warm White SOL lights require a 12 volt AC transformer. A Driver is located approximately
6" from the end of the cord and is labeled "DO NOT REMOVE" The Driver converts AC
current to DC before it is sent to the LED light. Removing the Driver or tampering with the
cords between the Driver and the light fixture will damage the LED and void the warranty.
The light can be connected to a larger outdoor lighting system by cutting the cord and
stripping the wires, however this must be done on the 12 volt AC input side of the driver.
Installation
Spout Light Installation
The Spout Light can be installed behind a wall, shining through a wall spout (see Figure 1)
or under a core-drilled stone or pot (see Figure 2). The light is designed to be installed in
any tee that has 1" female threads. If the tee is larger than 1", a reducing bushing with 1"
female threads will be needed. Install the light in the back of the tee, with the light facing
the water outlet. Apply a small amount teflon tape or paste to the threads of the light
and thread the light into the fitting. Do not use the cord to twist in the light or allow it
to become twisted when tightening. You can remove the driver from the cord when pulling
Figure 1.
1½" T
1½" x 1"
Reducing
bushing
2
it through conduit. Once the cord is
throughthe conduit, reattach the driver
before connecting the light to a power
source. Failure to reattach the driver
will damage the light and void warranty
.