Troubleshooting Guide - Atlantic SOLWSL2 Manual De Operación

Figure 5.
Hardscape Wall Light Maintenance
Make sure that the power is off
before attempting to replace the light.
Remove the screws on the existing light,
being careful not to let the light strip fall,
as this could break the plug connecting
the light to the cord. Lower the light and
squeeze the locking clip; this will allow
the plug to be separated. Plug in the
new light, making sure the gasket has not
moved or shifted and that the notched
edge of the light strip is between the two
ridges on the cord gasket. Align the screw
holes and hand tighten the screws.
Warranty
All SOL Lighting carries a five-year limited warranty. This limited warranty is
extended solely to the original purchaser commencing from the date of the
original purchase receipt and is void if any of the following apply:
• The cord has been cut or altered after the Driver.
• The light body / LED components have been misused or abused.
• The light body / LED components have been disassembled or modified other
than as described in this manual.

Troubleshooting Guide

Always turn off power before inspecting the SOL lights. Failure to observe this precaution
can result in a serious accident.
Before ordering repairs, carefully read through this instruction booklet. If the
problem persists, contact your dealer.
Problem
LED light will
not illuminate
4
-
Replacing the LED Light Strip
Figure 6.
Possible Cause
No power to outlet
No Power to LED
LED is broken / defective
Possible Solution
Confirm power to outlet.
Check all connections, ensure
cord is not cut or damaged.
Replace LED bulb