Removing Blade - Textron Greenlee LCS-144 Manual De Instrucciones

Operation—Power Tool (cont'd)
Follow these steps:
1. Remove the battery pack from the tool.
2. Remove any cutting debris from blade area.
3. Use the retracting handle to retract (open) the
lower guard.
4. Install the blade as illustrated in Fig. 3. Make sure
that both the direction arrow on the blade and the
direction arrow on the transparent guard point in
the same direction.
5. Set the outer washer in place.
6. Insert the hex bolt.
7. Hold the spindle lock button down to prevent the
blade from rotating.
8. Tighten the hex bolt securely with the provided
hex wrench. Store the hex wrench.
Note: Keep the hex wrench in the storage slot on
the tool's body when not in use.
Failure to follow these instructions could result in
serious personal injury.
Outer washer
Place the protrusion of the
outer washer into the position
of the washer.
Tighten
Retracting handle
Loosen
Hex bolt

Removing Blade

The blade will be hot right after cutting. Be sure to
let the blade cool down before removing it.
Follow these steps:
1. Remove the battery pack from the tool.
2. Hold the spindle lock button down to prevent the
blade from rotating.
3. Use the provided hex wrench to loosen the hex
bolt.
Note: Keep the hex wrench in the storage slot on
the tool's body when not in use.
4. Remove the hex bolt and outer washer.
5. Use the retracting handle to retract (open) the
lower guard.
6. Carefully remove the blade.
7. Clean the tool if necessary.
• Be careful to avoid cutting hands on the blade.
• When disposing of a blade, secure it inside heavy
or corrugated paper to prevent anyone from being
cut by the discarded blade.
Inner washer
Place the inner washer with cut-out
facing you.
Lower guard
14
Spindle lock button
Fig. 3