Control Panel; Led Light - Textron Greenlee LCS-144 Manual De Instrucciones

Operation—Power Tool (cont'd)

Control Panel

• DO NOT STARE INTO WORK LIGHT. Use of controls
or adjustments or performance of procedures
other than those specified herein may result in
hazardous radiation exposure.
• Do not use it as a substitute for a regular
flashlight.
(1)

LED Light (1)

Note: To use the LED light, depress the trigger once.
Press the LED light button.
Pressing toggles the LED light on and off.
The light illuminates with very low current, and it does
not adversely affect the performance of the tool during
use or its battery capacity.
The built-in LED light is designed to illuminate the
small work area temporarily. After installing the battery
or if tool has been idle for more than 5 minutes, the
work light will not illuminate until the power switch
has been initially depressed.
This product has a built-in LED light. This product
is classified into "Class 1 LED Product" to IEC (EN)
60825-1:2001.
Class 1 LED Product
(2) (3)
LED light
Fig. 9
Overheat Warning Lamp (2)
Off
(normal operation)
The overheating protection feature halts tool operation
to protect the battery pack in the event of overheat-
ing. The overheat warning lamp on the control panel
flashes when this feature is active.
• If the overheating protection feature activates, allow
the tool to cool thoroughly (at least 30 minutes).
The tool is ready for use when the overheat warning
lamp goes out.
• Avoid using the tool in a way that causes the over-
heating protection feature to activate repeatedly.
• If the tool is operated continuously under high-load
conditions or if it is used in hot-temperature condi-
tions (such as during summer), the overheating
protection feature may activate frequently.
Battery Low Warning Lamp (3)
Off
(normal operation)
Excessive (complete) discharging of lithium-ion
batteries shortens their service life dramatically. The
tool includes a battery protection feature designed to
prevent excessive discharging of the battery pack.
The battery protection feature activates immediately
before the battery loses its charge, causing the battery
low warning lamp to flash.
If you notice the battery low warning lamp flashing,
charge the battery pack immediately.
17
LCS-144
Flashing: Overheat
Indicates operation has been
halted due to battery overheating.
Flashing (no charge)
Battery protection feature active.