MFL62883001-Edit1-en 3/17/10 3:46 PM Page 9
PREPARATION
ACCESSORIES
Ensure that the following accessories are included with your TV. If an accessory is missing, please contact the
dealer where you purchased the TV.
The accessories included may differ from the images below.
Owner's Manual
M4x28
M5x14
x 4
Bolts for stand assembly
(Refer to P.14)
(Except 60PK550R)
Polishing Cloth
(Not included with all models.)
* Wipe spots on the exterior only with
the polishing cloth.
* Do not wipe roughly when removing
stain. Excessive pressure may cause
scratch or discoloration.
The ferrite core can be used to reduce the electromag-
netic waves in the PC Audio cable.
Wind the PC Audio cable on the ferrite core twice, and
Ferrite Core
then plug the cables into the TV as shown in the fol-
(Gray)
lowing picture.
(This feature is not
Place the ferrite core close to AUDIO IN(RGB/DVI) jack
available for all
on the display.
models.)
Place the ferrite core close to
AUDIO IN(RGB/DVI) jack on the display.
or
Remote Control
x 3
Protection Cover
(Refer to P.15)
Ferrite Core
(Gray)
(This feature is
available only
42PJ*** models.)
Tie Band
AUDIO IN
(RGB/DVI)
1.5V 1.5V
Batteries
(Some models)
x 2
Cable Holder
You must connect it to the antenna
(Refer to P.17)
wire after fixing in Antenna Input.
This adapter is only supplied in
TV
Wall
Ferrite core can be used to reduce RF noise when connecting
the RF cable.
The closer the location of the ferrite core to the "ANTENNA
IN", the better it is.
Ferrite core can be used to reduce the elec-
tromagnetic waves that may interfere with the
Ferrite Core
TV. Install the Ferrite core on the power cable
(Black)
close to the wall plug.
(This feature is not
available for all
models.)
close to the wall plug.
Power Cord
RF Adapter
(Some models)
A A r r g g e e n n t t i i n n a a .
9