Installing The Canopies; Operation; Using The Stroller - Britax B-LIVELY Double Guia Del Usuario

Installing the Canopies

1. Place the canopy stay bracket over the
mounting pin on the side of the stroller
frame and rotate until the canopy stay
bracket locks into place.
NOTE: There is a left and a right
canopy. Install each canopy so that the
canopy brackets face the outside of the
stroller frame.
2. Snap the outer support strap to the
frame on the outside of the stroller
handle, and tighten the support strap
by connecting it to the hook and loop
fastener under the canopy flap.
3. Insert the inner support strap through
the slot at the center of the stroller
handlebar. Tighten the support strap
by connecting them to the hook and
loop fasteners under the canopy flap.
4. Attach the hook and loop fasteners
around the outer edge of the canopy
and hood to the stroller.
5. Repeat for the canopy on the other
side.
8

Operation

Using the Stroller

Folding the Stroller
IMPORTANT: Always apply brake and remove children before folding
the stroller.
1. Press the frame release button.
NOTE: Do not continue to hold the
frame release button once pressed.
2. Remove your hand from hinge area
and lift both frame release straps
in the middle of the seat until the
stroller collapses and the chassis lock
engages, if used.
9