Installation - Husky H4840GHVSG Manual Del Usuario

Installation

1
Cleaning the air hose
□ A 1/4" air hose is required, with a maximum length of 25 ft .
□ Clean the air hose of accumulated dust and moisture
before connecting it to the air supply .
NOTE: If a longer air hose is required, connect a 3/8" air
hose to the 1/4" air hose to ensure the spray gun has the
necessary air supply .
2
Connecting to the air supply
□ Always use clean dry air . Excessive moisture and dirt will
greatly reduce the life of any air motor . We recommend the
installation of an in-line filter-regulator as close to the tool
as possible .
□ Ensure all hoses and fittings are the correct size and
secured tightly .
WARNING: Lubricators should not be used with spray
guns . The use of an inline lubricator will damage the paint
finish .
Recommended Air Line Set-Up
Part Description
A Spray Gun
B Regulator
C Quick Plug
D Quick Coupler
E Air Hose
F In-line Filter
G Air Compressor
5
Please contact 1-888-43-HUSKY for further assistance .
HUSKYTOOLS .COM