Operation; Operating The Spray Gun - Husky H4840GHVSG Manual Del Usuario

Operation

1

Operating the spray gun

□ A low pressure at the spray cap minimizes over-spray,
eliminating paint waste.
□ This air operated spray gun is designed to perform a variety of
of compressor air. This gravity feed spray gun features the
HVLP (high volume low pressure), which enhances the transfer
to conventional spraying.
□ Do not exceed the maximum air pressure of 40 psi.
□ The trigger lever of this gun has a two-step design. Press
lever to the second step to connect the paint material.
2
. Press the trigger
6
□ Adjust the air pressure with the trigger pulled and the air
control knob fully open. If reduced air pressure is desired
for some area of the spray job, use the air compressor
regulator or air control to reduce pressure as necessary.
□
clockwise.
knob counterclockwise.
□ Set the pattern size to the desired shape. For a full pattern,
turn the pattern control knob counterclockwise. For a
round pattern, turn the pattern control knob clockwise.
□
.
3
□ The direction of the fan (horizontal or vertical) can be
adjusted by loosening the air cap ring and turning the air
cap 90 degrees.
1
2
□
counterclockwise. Observe the spray pattern on the
atomization is achieved.
Pattern Control
Knob
(1)
1
Fluid Control
2
Knob
(2)
Air Control
Knob
(3)
Air Cap
(1)
Air Cap Ring
(2)
3
Horizontal Fan
(3)
Vertical Fan
4
(4)