The frost protection function can also be set in this
CONFIGURATION 4
stove to a storage tank without coil.
The stove will switch on based on the temperature
read by the probe in the storage tank, and will
switch off based on the stove return temperature.
The frost protection function can also be set in this
CONFIGURATION 5
"Everspring" system.
The stove will regulate the power according to
the ambient temperature read by the sensor on
the "Everspring" system. It will also be possible to
handle various levels of ventilation of "Everspring"
directly from the stove. In summer mode, the
coupled to the "Everspring" system.
It is possible to set the "Eco-mode" function to
ensure that the stove shuts off or restarts according
to the room temperature set.
5.10 IMPROVING THE COMBUSTION
A good combustion depends on several factors
(type of installation, operation and maintenance
conditions, type of pellet etc ..)
the combustion of the stove.
If at the end of combustion in the brazier are many
waste, it is advisable to change the combustion
most satisfactory solution.
Refer to section "improving the combustion" of
the user manual.
6 MAINTENANCE
6.1 MAINTENANCE
The stove may only be maintained by an authorised
technical service centre.
Prior to effecting any maintenance operation,
adopt the following precautions:
-
Make sure that the stove is completely cold.
-
Make sure that the ashes have gone out
completely.
-
Use the personal protective equipment
-
Make sure the mains power is off at the master
power switch.
-
Ensure that the power supply cannot be
restored accidentally. Remove the power plug
from the socket.
-
Always use proper tools.
-
Once maintenance or repair activities are
completed, reinstall all the protections and
reactivate all the safety devices prior to
restarting the system.
6.1.1
This must be done at least once a year, or every 4
tons of pellets.
If it is not kept clean, the stove may experience
problems including:
-
poor combustion
-
blackened glass
-
blocked brazier, accumulated ash and pellets
-
ash and excessive encrustations on the heat
33