Parts Of The Machine; General Safety Rules; Work Area; Electrical Safety - Ega Master PRESSMATIC MINI Manual De Instrucciones

ENGLISH
1. Pressing jaw
2. Pressing contuor
3. Pressing tongs
4. Bolt
5. Tong retaining bolt
6. Housing grip
7. Inching switch
8. Pistol grip
Warning!
Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/
or serious injury. Then term "power tool" in all of the warnings listed below refers to your mains operated
(corded) power tool or battery operated (cordless) power tool, also machines and electric units. Only use
the power tool for the purpose for which it was intended, with the due attention to the general safety and
accident prevention regulations.
Warning!
• Keep work area clean and well it. Cluttered and dark areas invite accidents
• Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids,
gases or dust. Power tools create sparks which may ignite the dust or fumes.
• Keep children and bystanders away while operating a power tool. Distractions can cause you lose
control.
• Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs
with earthed power tools. Unmodified plugs and matching outlets will reduce risk of electric shock. If the
power tool comes with an earthed wire, the plug may only be connected to an earthed receptacle. At
work sites, in damp surrounding, in the open or in the case of comparable types of use, only operate the
power tool off the mains using a 30mA fault current protected switch (FI breaker).
• Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric shock if your body is earthed or grounded.
• Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of
electric shock.
• Do not abuse the cold. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord
away from heat, oil, sharp, edges or moving parts. Damaged or entangled cords increase the risk of
electric shock.
• When operating a power tool out doors, use an extension cord suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of electric shock.
10

PARTS OF THE MACHINE

1
2
3
4

GENERAL SAFETY RULES

WORK AREA

ELECTRICAL SAFETY

5
6
7
8