Ega Master PRESSMATIC MINI Manual De Instrucciones página 16

Cause:
a. Damaged or worn pressing tongs/pressing contour.
b. Incorrect pressing tongs (pressing contour, size) inserted.
c. Unsuitable matching of compression sleeve, pipe and support sleeve.
Pressing jaws close unevenly when the pressing tongs are not loaded.
Cause:
Pressing tongs have been dropped, compression spring is bent.
IMPORTANT!
The maker will not take responsibility for damage or malfunction as a result of the Testing Pump being
incorrectly used or, applied for a purpose for which it was not intended.
For ordering spare parts, please refer to the Spare Parts Drawing and note the needed number.
According to Waste Electrical and Electronic Equipment directive (WEEE), these ones must be
collected and arranged separately. If you have to throw them out, please, do not use the usual rubbish.
Please, contact your distributor for free recycling.
The maker guarantees to the machine owner 12 months against any manifacture defect.
This guaranteee do not cover the parts wich are consumables.
Note: to apply the guarantee its necesary to send the "GUARANTEE CERTIFICATE" duly filled
within one week after purchased the machine to the maker.
16
Problem
NOTES
GUARANTEE