Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
U-
HANDLE
INSTALL METAL SHIELD
Tools Required: 8 x 10 mm Open-end Wrench, Screwdriver, T-
wrench, Locking Tool
Parts Required: Metal Shield, Shield Bracket,
3 - 5 x 10 mm screws w/captivated flat and lock-
washer, (metal shield to gear housing).
2 - 5 x 8 mm screws, 2 - 5 mm nuts, 2 - 5 mm lock-
washers, (bracket to shield).
2 - 5 mm nuts, 2 - 5 mm lockwashers
(bracket to gear housing)
1.
If installed remove nylon line head, upper fixing plate, shield
plate, and plastic shield.
a.
Align locking hole in upper plate with notch in edge of gear
housing and insert head locking tool (A).
b.
Remove line head (B) by turning it clockwise until head is
completely off of shaft.
c.
Remove locking tool.
d.
Remove three screws holding shield plate (D) and plastic
shield (C) to gear housing.
e.
Retain line head (B), upper fixing plate (E), shield plate, and
plastic shield (C) for conversion back to nylon line head
operation.
2.
Loosely attach bracket (F) to shield (G) and attach shield to
bottom of gear housing (H) with hardware provided.
3.
Tighten all shield hardware.
INSTALL OPTIONAL BLADE
Tools Required: Locking Tool, T-Wrench.
Parts Required: Upper Plate w/ 20 mm pilot, Lower Plate, 10 mm
Nut, 2 x 25 mm Split Pin, Blade.
1.
Install upper plate (I) on splined PTO shaft, pilot side down.
2.
Install Blade (J) on upper plate pilot. Blades must be installed so
that rotation arrow on blade faces gear case. Secure blade with
Lower fixing plate (K), and 10 mm nut (L). Turn nut counter-
clockwise on PTO shaft to tighten.
3.
Align hole in upper plate with notch in gear housing, and insert
locking tool (A) to prevent splined shaft from turning. Arrow on
gear housing points to notch. Tighten 10 mm nut securely.
C
K
I
OMBO
IT
NSTALLATION
I
NSTRUCTIONS
C
D
F
G
A
5
A
B
C
E
H
I
J
K
L
M
Publicidad
Tabla de contenido
