Auto Attendant; Maintenance Call; Alarm Control Unit Monitoring - DELTA DORE TTRTC TYXAL+ Manual De Instalación

7.8 Auto attendant

The auto attendant enables you to obtain vocal information on the status of your
installation when you are near the telephone transmitter (e.g. "your alarm system
is on"). You can activate or deactivate it.
Ê Enter the installer code (123456, by default)
and confirm with OK.
Ë Press Settings, then select the menu:
Installation > Products > Configure
Ì Press the button of the transmitter or select it from the
list of products by clicking on "Browse".
Í Select the "Auto attendant" menu, then "Activate"
or "Deactivate" (Î).

7.9 Maintenance call

A call cycle is triggered each time the system is switched to maintenance mode.
This menu allows you to disable this maintenance call cycle, for example during
activation, to prevent untimely calls.
It is important to reactivate the Maintenance call after the activation.
Ê Enter the installer code (123456, by default) and confirm with OK.
Ë Press Settings, then select the menu:
Installation > Products > Configure
Ì Press the button of the transmitter or select it from the
list of products by clicking on "Browse".
Í Select the "Maintenance call" menu, then "Activate" or
"Deactivate" (Î).

7.10 Alarm control unit monitoring

Monitoring is used to trigger a call if the transmitter does not
receive information from the alarm control unit for more than
two hours. This function is enabled by default.
To disable this function:
• From the main menu, type #81 then type 0
To enable this function:
• From the main menu, type #81 then type 1.
PSTN transmitter
Incoming calls
Auto attendant
Alarm control unit monitoring
Return
Incoming calls
Auto attendant
Maintenance call
Return
.
61
Auto attendant
Activate
Auto attendant
Ok Return
<
Return
PSTN transmitter Maintenance call
Ok Return
<
Return
EN
>
Ok
Deactivate
Ok
Activate >
Maintenance call
Ok
Deactivate
Ok